List of Topics

SfC Home > Physics > Electricity >

 

Feedback Comments on Electricity

by Ron Kurtus

A total of 724 comments and questions have been sent in. They are listed according to date.

You can read them to further your understanding of the subject.



List of next 10 letters

Topic

Title

Country

DC Speed of electron flow through in DC current Pakistan
 
DC Circuits On/Off switch for 110 Volt DC USA
 
AC World Voltages AC frequency date in Japan incorrect Australia
 
AC World Voltages Buying device on eBay from Italy Australia
 
DC Fundamental units Pakistan
 
AC Transformers Risks in using a transformer South Africa
 
Electric Charge Why don't electrons repel each other in orbit? Pakistan
 
AC World Voltages Going to Australia on vacation USA
 
Ohm's Law Ohm's law and DC generator India
 
AC World Voltages Increase voltage from 100v to 240v Kenya
 

Next 10

 




First 10 letters


Speed of electron flow through in DC current

Topic: DC

Question

November 22, 2014

in which speed electron flow through in Dc current

amjad - Pakistan

25578

Answer

The speed of an electron in a DC circuit is also called the electron drift velocity. Electricity passing through a copper wire of radius 1 mm, carrying a steady current of 10 amps, has a drift velocity of only about 0.024 cm/sec.

It surprises many scientists how slow they travel in a wire. However, the effect of that movement causes the electricity to travel close to the speed of light, because of the movement of the electromagnetic field.

Back to top


On/Off switch for 110 Volt DC

Topic: DC Circuits

Question

November 13, 2014

Is there an on/off switch for 110DC as shown in your diagram. Or can I use a standard 15a or 20a light switch?

Bob - USA

25532

Answer

It depends on the amperage of the circuit. The list of 110V DC Power Supplies shows a range of amps from 4.5A to 40A.

If the current is less than 20A, you can use such a light switch.

Back to top


AC frequency date in Japan incorrect

Topic: AC World Voltages

Question

October 30, 2014

On your "Electricity - AC World Voltages" page it states that the 50Hz/60Hz split in the Japanese power system happened after WWII.

Wikipedia states it happened about 50 years before that.


Eastern Japan (including Tokyo, Kawasaki, Sapporo, Yokohama,
and Sendai) runs at 50 Hz; Western Japan (including Okinawa,
Osaka, Kyoto, Kobe, Nagoya, Hiroshima) runs at 60 Hz.
This originates from the first purchases of generators
from AEG for Tokyo in 1895 and from General Electric for
Osaka in 1896.[3][4]

Tom - Australia

25491

Answer

Thanks for pointing that out to me. I noticed that the resource I used that stated the split in frequencies happened after WWII no longer exists.

I'll make the correction.

Thanks again for the information and sorry for the inconvenience.

Back to top


Buying device on eBay from Italy

Topic: AC World Voltages

Question

October 28, 2014

I am considering buying a MiniDisc combo deck on Ebay,from Italy. Their current is 230 volts at 50hz.In Australia we have 240 volts at 50hz.Will the unit function properly in Australia,on 240 volts? Dennis Moore.

Dennis - Australia

25482

Answer

There is about a 10% variation in the designated voltages, so the difference between 240 VAC and 230 VAC should not be a factor. However, you do need to make sure the Italian outlet plugs will fit in your Australian outlets.

See Electricity in Italy for pictures of their outlet plugs. You would probably need some sort of adapter to fit your outlets.

Back to top


Fundamental units

Topic: DC

Question

October 22, 2014

my question is please can you tell me what is the fundamental unit of direct current and fundamental unit of alternating current?

amina - Pakistan

25469

Answer

There are three fundamental units for AC and DC electricity. Current is measured an amperes (also called amps), voltage is measured in volts, and resistance is measured in ohms.

These fundamental units are related by the equation: V = IR.

AC electricity has another factor: frequency.

Back to top


Risks in using a transformer

Topic: AC Transformers

Question

October 15, 2014

1. what are the risks/problems of using DC and AC Transformers?
2. what does the two transformers used for? (DC and AC Transformers)

Tonia - South Africa

25450

Answer

If you use the a transformer indented for lower voltages with a high voltage input, it could overheat or blow out.

Transformers are used to change the voltage to make it more usable.

Back to top


Why don't electrons repel each other in orbit?

Topic: Electric Charge

Question

October 10, 2014

electrons are charged negatively charged particles as like charges repel each other then how electones are moving in an orbital why they dont repel eachother.

Moon - Pakistan

25439

Answer

Electrons in the orbits or shells of an atom are separated, so to an extent they do repel each other. But a bigger question is why the negatively charged electrons do not fall into the positively charged nucleus.

The reason for both situations is that in very close distances--like with an atom--the Quantum Theory takes effect and properties at greater distances do not hold.

Back to top


Going to Australia on vacation

Topic: AC World Voltages

Question

September 21, 2014

HI I am going to Australia on vacation and I want to get an electrical outlet converter that uses 240 volt AC 50 hertz system. Do you know where I can find that and want is this called?

Corey - USA

25375

Answer

You can see some good information from Australia: Power and Appliances.

Another good site is Aust. Electrical Converters that includes a link to Amazon for one that costs about $25.

It is also good to check with your travel agent, if you are using one.

Have a good time on your trip.

Back to top


Ohm's law and DC generator

Topic: Ohm's Law

Question

September 11, 2014

ohms law is applicable for generator and how

upendra - India

25350

Answer

The output current from a DC generator is I = V/R(i), where R is the internal resistance of the generator.

The current in the DC circuit is I = V/R, where V is the output of the generator and R is the resistance of the circuit.

Back to top


Increase voltage from 100v to 240v

Topic: AC World Voltages

Question

August 31, 2014

I have ajapanes generator of 100v. Can i use it in Kenya where the voltage us 240v and how can the voltage be increased from 100v-240.

philip - Kenya

25329

Answer

The 100 volt AC is too low to power devices requiring 240v. You would have to use a 100 to 240 VAC voltage converter or AC transformer.

Back to top

Next 10


Summary

Hopefully, this reader feedback has helped provide information about Electricity issues.


Be electrifying


Resources and references

The following are some resources on this topic.

Websites

Electricity Resources

Books

Top-rated books on Electricity


Questions and comments

Do you have any questions, comments, or opinions on this subject? If so, send an email with your feedback. I will try to get back to you as soon as possible.


Where are you now?

School for Champions

Physics topics

Electricity Feedback Comments




Electricity topics

DC Electricity

AC Electricity

Also see



Let's make the world a better place

Be the best that you can be.

Use your knowledge and skills to help others succeed.

Don't be wasteful; protect our environment.

You CAN influence the world.




Live Your Life as a Champion:

Take care of your health

Seek knowledge and gain skills

Do excellent work

Be valuable to others

Have utmost character

Be a Champion!


The School for Champions helps you become the type of person who can be called a Champion.